Processing Method

  • Categories:Products
  • Time of issue:2020-02-13 00:00:00
  • Views:0
Description:
Description:
Information

Processing Method

 

The fabrication of ALUTILE® Aluminium Composite Panel can be done by extremely simple woodworking tools or metal tools, such as shearing, sawing, milling, punching, pressing, folding, bending to arc and inverse arc, small radius round angle, inner and outer turning angle, right angle and etc.


1 Cutting

It can be cut into all kinds of shape by using water jet, contour milling machine, forming saw and curve saw.

2 Shearing

The shearing can be done by shearing machine. When shearing, please make sure there is a gasket under the blanking tools.

3 Hole punching

General eyelet machine can punch holes on panels with any thickness. When cutting, please use steady installation tools and make sure there is a narrowest gap.

4 Bending

Bending can be done by folding table or brake press. The bend inside diameter is about 10 times thicker than the panel thickness.

4 Drilling

Panel can be drilled by twist drill, which is usually used for drilling aluminum and plastic.

4 Riveting

The riveting can be done by simple tools, rivet or blind rivet. When using it for outside, please take the heat expanding into your consideration.

4 Cut Thread

Using general eguttulate wood, metal sheet and metal screw. When using it for outside, please take the heat expanding into your consideration.

4 Welding

The panel can apply to heat air welding. Use heat air weld facility to heat and weld plastic core and plastic welding rod.

Scan the QR code to read on your phone

GAN ICP15001297 © 2020  ALUTILE. All Rights Reserved.  Powered by www.300.cn